ANALOGUE DRIVE BY WIRE CRUISE CONTROL AND SPEED LIMITER
retrofit cruise control, aftermarket cruise control, cruise controls for cars, cruise control kits, cruise control suppliers, Cruise control, cruise controls, speed control, speed controls, autocruise
The AP900 Cruise Control allows the driver to cruise at a desired speed by monitoring the vehicle road speed and by finely adjusting the vehicles throttle to maintain that speed.
The Speed Limiter feature allows the driver to select a maximum speed that they do not want to exceed (this feature is useful whilst driving in areas with average speed cameras and built up areas)
Options of different control stalks and command modules with set, accelerate, resume, decelerate and On/Off buttons (CM35 has additional coast and memory features).
All stalks and command module allow you to tap up or tap down the set speed by 1kph/0.62mph.
• Helps to reduce fuel consumption and exhaust emissions (lowering your carbon footprint).
• Allows you to concentrate on the road and not your speedometer.
• Helps avoid unintended speeding.
• Allows you to set a maximum vehicle speed limit in safety camera enforcement areas.
• Reduce driver fatigue and enhance driver comfort.
The Cruise Control systems is fitted with numerous safety features, which will disengage the system by any of the following methods:
• Depressing the brake pedal.
• Press the OFF/Coast button of the command module/stalk.
• Over-rev protection of the engine when a clutch switch is fitted (manual gearbox optional).
• Decelerating to below 75% of the set speed.
• Over speed dropout (150% of the set speed).
• Brake light bulbs or brake light fuse failure.
Note: Some vehicles may require additional interfaces for connection into vehicle speed signal circuits and clutch switch circuits.